Optimization of Carboxymethylcellulose (CMC) for Environmentally Friendly TNI Rations Packaging Formulation Based on Polysaccharides
(1) Department of Chemistry, The Republic of Indonesia Defense University, Bogor, Indonesia
(2) Department of Chemistry, The Republic of Indonesia Defense University, Bogor, Indonesia
(3) Department of Chemistry, The Republic of Indonesia Defense University, Bogor, Indonesia
(4) Department of Chemistry, The Republic of Indonesia Defense University, Bogor, Indonesia
(5) Department of Chemistry, The Republic of Indonesia Defense University, Bogor, Indonesia
(*) Corresponding Author
Abstract
Conventional plastic waste is difficult to decompose and has the potential to leave traces in the TNI field of operations. This condition has encouraged the development of polysaccharide-based bioplastics as a safe, environmentally friendly, and easily degradable alternative for ration packaging. This study aims to optimize the concentration of carboxymethylcellulose (CMC) as a filler in the formulation of polysaccharide bioplastics for TNI ration packaging. The method used was a literature review on the effect of CMC addition on the physical and mechanical properties of bioplastic films. The results of the study showed that the addition of CMC generally increased tensile strength and water absorption, but also accelerated dissolution and the rate of biodegradation. The optimum concentration varied depending on the type of polymer used. Therefore, the selection of CMC concentration must be adjusted to the application objective, whether to increase mechanical strength or accelerate biodegradation, and needs to be validated through mechanical and degradation tests under real conditions. Compliance with bioplastic quality standards and the use of safe additives are highly recommended for application in TNI ration packaging.
Keywords
Full Text:
PDFReferences
Puspita, S. (2018). Indonesia penyumbang sampah plastik terbesar kedua di dunia. Kompas. com, 19
Vianka, M. I. (2021). Penegakan Hukum Lingkungan Atas Pembuangan Limbah Plastik Di Indonesia. MORALITY: Jurnal Ilmu Hukum, 7(2), 245-256.
Indrarti, L., Indriyati, I., Syampurwadi, A., & Pujiastuti, S. (2016, February). Physical and mechanical properties of modified bacterial cellulose composite films. In AIP Conference Proceedings (Vol. 1711, No. 1). AIP Publishing.
Furqon, Z., & Aulia, H. N. (2019, April). Pemanfaatan Sampah Plastik Menjadi Fraksi Naphtha Sebagai Bahan Baku Alternatif Petrokimia. In Seminar Nasional Teknik Kimia" Kejuangan" (p. 3).
Dalilah, E. A. (2021). Dampak Sampah Plastik Terhadap Kesehatan dan Lingkungan
Aritonang, S., Rhomadon, F. I., Subiakto, A. K. H., & Nismarawati, A. K. (2024). Pemanfaatan Limbah Biomassa Sebagai Plastik Biodegradable Yang Diaplikasikan Pada Food Packaging Ransum Tni. Jurnal Rekayasa Material, Manufaktur dan Energi, 7(2).
Radhiyatullah, A., N. Indriyani, M. Hendra dan S. Ginting. 2015. Pengaruh Berat Pati dan Volume Plasticizer Gliserol terhadap Karakteristik Film Bioplastik Pati Kentang. Jurnal Teknik Kimia USU. 4 (3) : 35-39.
Yustinah, Y., Syamsudin, A. B., Solekhah, P. P., Novitasari, G. P., Nuryani, F., Djaeni, M., & Buchori, L. (2023). Pengaruh Jumlah Kitosan dalam Pembuatan Plastik Biodegradabel dari Selulosa Sabut Kelapa dengan Pemplastik Gliserol. JRST (Jurnal Riset Sains dan Teknologi), 7(2), 143-149.
Saptorahardjo, A. (2015). Industri Bioplastik Biodegradable di Indonesia.
Selpiana, S., Patricia, P., & Anggraeni, C. P. (2016). Pengaruh penambahan kitosan dan gliserol pada pembuatan bioplastik dari ampas tebu dan ampas tahu. Jurnal Teknik Kimia, 22(1), 18-26.
Aboulfotouh, M. E., Ali, H. E. S., & Mohamed, M. R. (2024). Nano-modifications of edible materials using ionizing radiation for potential application in active food safety. Functional Composite Materials, 5(1), 8.
Alfiani, A., & Sasria, N. (2023). Pengaruh carboxymethyl celullose terhadap karakteristik bioplastik menggunakan tandan kosong kelapa sawit dan pati ampas tahu. Jurnal Integrasi Proses, 12(1), 12-16.
Coniwanti, P., Pertiwi, D., & Pratiwi, D. M. (2014). Pengaruh peningkatan konsentrasi gliserol dan vco (virgin coconut oil) terhadap karakteristik edible film dari tepung aren. Jurnal Teknik Kimia, 20(2).
Febrianti, A. N. (2024). Pengaruh Penambahan Carboxymethyl Cellulose (CMC) Dan Gliserol Terhadap Karakteristik Bioplastik Dari Nata Kulit Buah Nanas Dan Air Cucian Beras (Doctoral dissertation, UPN Veteran Jawa Timur).
Hasan, M. (2007). Plastik Ramah Lingkungan dari Polikaprolakton dan Pati Tapioka dengan Penambahan Refined Bleached and Deodorized Palm Oil (RBDPO) sebagai Pemlastis Alami. Jurnal Purifikasi, 8(2), 133-138.
Indriani, S., Wijaya, M., & Syahrir, M. (2023). Sintesis dan Karakterisasi Bioplastik dari Pati Biji Nangka (Artocarpus heteropyllus) dengan Penguat CMC (Carboxy Methyl Cellulose). Jurnal Chemical, 24(1), 23-32.
Jacoeb, A. M., Nugraha, R., Putu, S., dan Dia, S. (2014). Pembuatan Edible Film Dari Pati Buah Lindur Dengan Penambahan Gliserol Dan Karaginan Edible Film from Lindur Fruit Starch with Addition of Glycerol and Carrageenan. JPHPI, 17(1), 14–21.
Kamaludin, M. A., Maryono, M., Hasri, H., & Rizal, H. P. (2022). Pengaruh Penambahan Plasticizer Terhadap Karakteristik Bioplastik dari Selulosa Limbah Kertas. Analit: Analytical and Environmental Chemistry, 197-208.
Karina, M. (2015). Penelitian dan Pengembangan Plastik Ramah Lingkungan di Indonesia. In Prosiding Seminar Nasional Kulit, Karet, dan Plastik ke-4 Yogyakarta, 28 Oktober 2015 (pp. 25–32).
Kumar, L., Ramakanth, D., Akhila, K., & Gaikwad, K. K. (2022). Edible films and coatings for food packaging applications: A review. Environmental Chemistry Letters, 1-26.
Linggi, R. A., & Pawarangan, I. (2018). Pengaruh Sampah Rumah Tangga Organik dan Non Organik Terhadap Lingkungan. Prosiding Semkaristek, 1(1).
Mukhlisien, M., Suhendrayatna, S., Montazeri, M., & Amar, H. (2021). Kajian Pembuatan Film Plastik Biodegradable Dari Ekstrak Bonggol Jagung. Jurnal Inovasi Ramah Lingkungan, 2(1), 5
Nee, F. C., & Othman, S. A. (2022). Preparation and Characterization of Irradiated Bioplastik from Cassava Peel–A Review. In Journal of Physics: Conference Series (Vol. 2169, No. 1, p. 012041). IOP Publishing.
Ningsih, E. P., Ariyani, D., & Sunardi, S. (2019). Pengaruh penambahan carboxymethyl cellulose terhadap karakteristik bioplastik dari pati ubi nagara (Ipomoea batatas L.). Indonesian Journal of Chemical Research, 7(1), 77-85.
Nurfauzi, S., Sutan, S. M., & Argo, B. D. (2018). Pengaruh konsentrasi CMC dan suhu pengeringan terhadap sifat mekanik dan sifat degradasi pada plastik biodegradable berbasis tepung jagung. Journal of Tropical Agricultural Engineering and Biosystems-Jurnal Keteknikan Pertanian Tropis dan Biosistem, 6(1), 90-99.
Pandey, V. K., Upadhyay, S. N., Niranjan, K., & Mishra, P. K. (2020). Antimicrobial biodegradable chitosan-based composite Nano-layers for food packaging. International journal of biological macromolecules, 157, 212-219.
Pasaribu, M. (2021). Produksi biodegradable plastic dari limbah kulit pisang dengan penambahan kitosan. In Prosiding Seminar Nasional Teknologi Industri (SNTI) (Vol. 8, No. 1, pp. 433-435).
Pérez-Puyana, V. M., Cortés-Triviño, E., Jiménez-Rosado, M., Romero, A., & Martínez, I. (2024). Pea protein-based bioplastiks crosslinked with genipin: analysis of the crosslinking evolution. Journal of Polymers and the Environment, 32(1), 31-44.
Purba, D. M., Harsojuwono, B. A., & Hartiati, A. (2019). Pengaruh Jenis dan Konsentrasi Plasticizer Terhadap Karakteristik Bioplastik Maizena (Doctoral dissertation, Udayana University).
Rafid, A. Z., Ardhyananta, H., & Pratiwi, V. M. (2021). Tinjauan Pengaruh Penambahan Jenis Filler terhadap Sifat Mekanik dan Biodegrdasi pada Bioplastik Pati Singkong. Jurnal Teknik ITS, 10(2), D49-D54.
Sarito, I. K., Harsojuwono, B. A., & Suwariani, N. P. (2022). Karakteristik Biokomposit Foam Maizena dan Glukomanan pada Perlakuan Konsentrasi Campuran Sorbitol dan TDI-80. Jurnal Rekayasa dan Manajemen Agroindustri ISSN, 2503, 488X.
Setiarto, R. H. B. (2020). Teknologi pengemasan pangan antimikroba yang ramah lingkungan. GUEPEDIA.
Standar Nasional Indonesia (SNI). 7188-7 :2022 : Kantong plastik mudah terurai.
Refbacks
- There are currently no refbacks.
 | Office Address: Faculty of Military Mathematics and Natural Sciences Republic of Indonesia Defense University Indonesian Peace and Security Center Complex, Sentul, Bogor 16810, Indonesia Email: munisi.unhanri@gmail.com | WhatsApp: +6285742313964 |
This work is licensed under a Creative Commons Attribution-ShareAlike 4.0 International License.
| Munisi: Military Mathematics and Natural Sciences View |